ACR Electronics Earlswood EW1MF Panduan Teknis - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Teknis untuk Kompor ACR Electronics Earlswood EW1MF. ACR Electronics Earlswood EW1MF 12 halaman. Multifuel stove

Halaman Cetak

Flue Requirements

The chimney must comply with current Building Regulations. Provision must

be made to provide access for cleaning the appliance, the flue gas

connector and the chimney flue.

The flue must be:

 In sound condition and provide sufficient draft

 Suitable for use with solid fuel burning appliances

 Free from deposits

 Well insulated

 At least 4.5m in height

The flue must not be:

 Shared with other appliances

 Weight bearing on the appliance

 A smaller diameter than the appliance flue collar size (125mm)

Assembly of the unit

The appliance is supplied assembled with the flue spigot in the top exit

position. If you intend to install the appliance using a rear flue connection,

the blanking plate should be swapped over as follows:

 Remove the internal baffle plate

 Remove the blanking plate retaining bar internally.

 Remove the flue spigot from the top exit by removing the securing bolts

and rope seal.

 Refit the rope seal and flue spigot to the rear exit and secure with the

bolts. Seal with fire cement.

 Refit the blanking plate to the top exit using the rope seal and retaining

bar

Maintenance

The chimney should be swept at least once a year together with the flue

pipe connection. Care should be taken to ensure that there is not a build

up of soot on the baffle and in the airways of the appliance.

If the appliance has not been operated for long periods, the flue should be

inspected and swept before use to ensure there are no blockages within

the flue.

The grate should be cleaned regularly and the ashpan emptied daily.

NEVER ALLOW THE ASH IN THE ASHPAN TO OVERFILL ALLOWING ASH TO BE IN

CONTACT WITH THE UNDERSIDE OF THE GRATE. This will overheat the grate

and cause premature wear and distortion.