ACR Heat HERITAGE N25 Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Perapian Dalam Ruangan ACR Heat HERITAGE N25. ACR Heat HERITAGE N25 10 halaman.

Halaman Cetak

Your stove is now assembled and can be put into place in the

fireplace and connected to the flue system. The internal stove base is

protected with a sheet of plastic – please remove this plastic at this point.

5. The canopy can now be attached to the stove. Take 1 right angle

bracket and using the holes provided, fix the bracket as per drawing to

the side panel and secure with 3 bolts. Repeat this procedure on the

opposite side panel.

Diagram of bracket

6. Place the canopy on the stove resting the base of the canopy on the

right angle brackets. Ensure there is a minimum 15mm gap between the

rear wall of the fireplace and the rear of the canopy to allow the hot air to

circulate.

When satisfied with the position of the canopy, attach each right angle

bracket into the canopy base and secure with the supplied nut & bolt.

7. Attach the base cover to the front of the appliance by sliding the cover

into the gap provided by the leg bolts.

SOME FACTS ABOUT YOUR STOVE

This appliance is fitted with air controls which should be operated as

follows:-

PRIMARY AIRSLIDE

(Located to the right hand side below the doors)

Pushed in = CLOSED

Pulled out = OPEN

SECONDARY AIRSLIDE

(Located to the right hand side above the doors)

Lever to the left = CLOSED

Lever to the right = OPEN

To open the door, point the door handle up. To close the door, point the

door handle horizontally.