Floe 8000 Manual Petunjuk Perakitan - Halaman 5

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Sistem Pengangkatan Floe 8000. Floe 8000 8 halaman. 24 volt vsd drive

steP 3 - - - - - - - - - - - - - - - - - - - - -

Clean and adhere the dual lock 5-1/4" down from the top of the corner post. (Fig. 3A) Attach the Advanced

Switch Control (ASC) to the hole in the top of the corner post with the nut, bolt, and washer provided.

(Fig. 3B) Connect "Advanced Switch Control" to the "VSD Power Unit" by removing the four screws in the

bottom cover. Inside the power unit is four wires with spade connectors. Connect these four wires with

spade ends to the wires on the Advanced Switch Control (ASC) with the corresponding

ends (Fig. 3C). The two small gauge wires on the ASC have female spade connectors

and it does not matter to which small gauge on the VSD power unit that they

connect to. The larger two wires have one male and one

female connector so they cannot be incorrectly wired.

Replace the cover on the bottom of the VSD Power Unit.

Fig. 3C

Fig. 3B

Page 5 of 8

Fig. 3A

Attach the Advanced Switch

Control to the winch post by

pressing Dual Lock pads together.