Coalesse SW 1 Manual - Halaman 6

Jelajahi secara online atau unduh pdf Manual untuk Perabotan Dalam Ruangan Coalesse SW 1. Coalesse SW 1 11 halaman. Replacement of knit and fabric components
Juga untuk Coalesse SW 1: Petunjuk Layanan Pelanggan (7 halaman)

Halaman Cetak
Coalesse SW 1 Manual
FOR LARGE ROUND AND SQUARE TABLES
NOTE: Go to page 3 for Standard Tables.
1.
Insert spanner tubes into 4-way
connector (1a) then tighten bolts (1b).
Place bases upside down on a protected
surface. Align spanner tubes to legs (1c).
If needed, lightly tap spanner to engage
into base. Hand tighten bolts (1d).
After all bolts are hand tightened, fully
tighten to 23
3-ft-lb torque.
2.
Turn all leveling glides to the lowest
position, then use two people to carefully
flip the substructure into an upright
position.
3.
Follow steps 3 through 8 on pages
4 & 5 for column & cone installation.
4.
Level cones.
5.
If grommet option is selected,
follow step 8 on page 5.
LEVELING
4-WAY
GLIDES
CONNECTOR
1c
1a
1d
SPANNER
TUBES
4
NOTE: Cone assemblies must be level
with each other to ensure proper fit of
joint on multi-piece worksurface tables.
1b
2
Page 6 of 11
939500440 Rev E