Coalesse SW 1 매뉴얼 - 페이지 6

{카테고리_이름} Coalesse SW 1에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Coalesse SW 1 11 페이지. Replacement of knit and fabric components
Coalesse SW 1에 대해서도 마찬가지입니다: 고객 서비스 지침 (7 페이지)

페이지 인쇄
Coalesse SW 1 매뉴얼
FOR LARGE ROUND AND SQUARE TABLES
NOTE: Go to page 3 for Standard Tables.
1.
Insert spanner tubes into 4-way
connector (1a) then tighten bolts (1b).
Place bases upside down on a protected
surface. Align spanner tubes to legs (1c).
If needed, lightly tap spanner to engage
into base. Hand tighten bolts (1d).
After all bolts are hand tightened, fully
tighten to 23
3-ft-lb torque.
2.
Turn all leveling glides to the lowest
position, then use two people to carefully
flip the substructure into an upright
position.
3.
Follow steps 3 through 8 on pages
4 & 5 for column & cone installation.
4.
Level cones.
5.
If grommet option is selected,
follow step 8 on page 5.
LEVELING
4-WAY
GLIDES
CONNECTOR
1c
1a
1d
SPANNER
TUBES
4
NOTE: Cone assemblies must be level
with each other to ensure proper fit of
joint on multi-piece worksurface tables.
1b
2
Page 6 of 11
939500440 Rev E