Coastal M-CBX9.6 2016 Panduan Pemilik - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Perahu Coastal M-CBX9.6 2016. Coastal M-CBX9.6 2016 16 halaman.

Store in a dry place.

burrow into a stored

necessary to store the boat deflated. If space is not an issue it is perfectly fine to

leave your boat inflated during off season. Your boat should be clean and dry. It is

not necessary to store your boat in a heated area. Make sure that your boat is not

stored "wet", especially if it will be subjected to freezing conditions during storage.

Freezing and thawing water can damage the seams of the boat.

If you are losing air pressure check the boat over for air leaks. There will be

normal air loss due to either the safe valve installed on the boat or due to

change in the temperature. The best way to find air leaks is dish detergent

mixed with water in a spray bottle. Start by checking the valves first. Spray

around the valve on a suspected air chamber. If you see bubbles forming,

check your valve fitting and base and be sure the valve insert is screwed on

tight and pushpin is in correct position. If the leak is not in the valve, then

spray the rest of the boat to find the leak. Spray the boat in small areas at a

time until the entire boat is covered. Once the leak is found, cut out a patch

large enough to overlap the damaged area by 1/2 inch on all sides. Center

the patch over the damaged area, and with a pencil trace the outline of the

patch. Apply masking tape around the perimeter of the outlined patch area

to ensure a tight and clean glue line. Clean the patch area on the boat as

well as the backside of the patch.



Apply three thin layers of adhesive with a short bristle brush, in a

circular pattern on the patch area on the boat. Allow each layer to

dry for 5 minutes before applying the next layer.



After applying the third layer on the boat, apply a layer of adhesive

to the patch and then put the patch to the prepared area and press

down firmly. Using a smooth object (a back of a tablespoon works

well), working from the center of the patch to the outside, force out

any air bubbles that may have been trapped under the patch.



After the patching is complete remove the masking tape and allow

24 hours drying time before pressurizing the repaired air chamber.

Important: It is recommended to do repairs in dry weather. Humidity

will decrease glue bond. Do not glue in cold temperatures.

Use care when storing as some rodents love to

inflatable. Store your craft rodent-safe. It is not

REPAIR PROCEDURES