10Bar Underwater Housing Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Kamera 10Bar Underwater Housing. 10Bar Underwater Housing 16 halaman. Underwater housing for olympus e-pl2
Juga untuk 10Bar Underwater Housing: Panduan Pengguna (15 halaman)

Halaman Cetak

4. Set-up Instructions

Special Note on Responsibility for Watertight Integrity

Each housing is individually inspected and hydrostatically tested in the factory. However, the

responsibility for ensuring the integrity of the watertight seal lies entirely with the user. 10Bar accepts no

liability for damage to, or loss of any equipment used with, or placed inside the housing. It is highly

recommended that an in-water test of the housing without the camera be carried out before the first dive,

after changing ports or alteration of housing configuration. This simple test can be done by lowering the

housing with ballast to the expected diving depth and then retrieved to check for leaks.

Key-hole Lock

The clear acrylic lid is secured to the housing by two key-hole locks.

Key-hole locks are simple, yet extremely secure mechanisms for locking down the housing lid.

Opening the Lid

Make sure the flash on the camera is turned off before opening the lid.

Turn the levers of the locks perpendicular to the wall

of the housing until the lock is released on both sides.

Use the universal key to insert in between the lid and body near the key-hole lock to push off the lid if

necessary

Pull out the lid by holding on the grip near the

lock