Coaxial Dynamics 81096 Buku Petunjuk - Halaman 7

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Ukur Coaxial Dynamics 81096. Coaxial Dynamics 81096 11 halaman.

The RJ-11 input connectors are provided for connection to the Line Sections.

AC power is applied through the fused receptacle on the rear panel. The mating power cord

is supplied. Power requirements are 115/230 VAC, 50/60 Hz.

1.3 Setup

The Model 81096 needs to be setup for the proper IP address for your system as well as the

proper element power ranges for your transmitter. The unit may be addressed using a

crossover cable connected to the Ethernet connector on the rear panel. The initial IP

address of the Model 80196 is 192.168.3.250 and the initial password is "123456". The

password may be changed by using the RS-232 connection and a terminal program.

Connect at 19200,8-N-1 flow control should be set for Xon/Xoff and press enter to access

the set-up menu. To reset the unit to original factory settings, turn the unit off. Press

and hold the reset switch when turning the power on.

Both the forward and reflected power ranges must be set for each port to match the

elements in use. Alarm set points are then set to match the desired trip points for high and

lower power on both forward and reflected channels.

If elements are ordered with the Model 81096, the ranges will be set at the factory on

port 1 and noted on the front of this manual.

Model 81096

- 5 -

8/2019