Da-Lite ACOUSTICAL IMAGER Buku Instruksi - Halaman 10

Jelajahi secara online atau unduh pdf Buku Instruksi untuk Layar Proyeksi Da-Lite ACOUSTICAL IMAGER. Da-Lite ACOUSTICAL IMAGER 13 halaman.

SUBWOOFER OPERATION

Move the Master Power switch (marked "Power") to

the "•" (On) position to use the sub-woofer. The

SUB300 subwoofer will automatically turn on or go into

standby (sleep) mode when left in the auto mode

("Auto/On" switch in the "Auto" position). When your

receiver or amplifier is off, or is not sending program

material to the subwoofer, the subwoofer will be in

standby mode (LED will be red). When the subwoofer

senses an audio signal, it will automatically turn on (LED

will be green). If the subwoofer does not sense a signal

after approximately 20 minutes, it will automatically go

into standby mode.

When the "Auto/On" switch is switched to the "On"

position, the subwoofer will remain on, whether or not

program material is playing.

If you will be away from home for an extended period of

time, or if the subwoofer will not be used, switch the

Master Power switch to the Off position.

VOLUME

Volume may be adjusted using the Subwoofer Level

control as shown.

CLEANING

Da-Tex, Dual Vision, Pearlescent, Cinema Vision, Da-Mat, High Contrast Da-Mat and High Contrast Cinema Vision surfaces can be

cleaned as follows:

Using a white clean cloth (100% cotton preferred) that is dampened with clear water, gently wipe the area in one

direction. Do not use a circular motion. Using a dry 100% cotton cloth, wipe dry after each cleaning session. To clean a

stubborn stain or a sticky surface, use denatured alcohol (methanol or methyl alcohol) following the same procedure as

for water. For extremely stubborn stains, use V M & P, Naphtha or Super Naphtha and follow the same procedure as for

water.

CAUTION

RISK OF ELECTRIC SHOC K

DO NOT OPEN

Subwoofer

Level

MIN

MAX

Subwoofer

Level

MIN

MAX

AUTO/ON

SWITCH

SUBWOOFER

LEVEL

POWER SWITCH