Da-Lite ACOUSTICAL IMAGER Buku Instruksi - Halaman 8

Jelajahi secara online atau unduh pdf Buku Instruksi untuk Layar Proyeksi Da-Lite ACOUSTICAL IMAGER. Da-Lite ACOUSTICAL IMAGER 13 halaman.

MOUNTING OPTIONS

8. Holding the Satellite Speaker with both hands, reinsert the ball portion of the Ball and Shaft into the Attachment

Plate.

9. Hand-tighten the Molded Nut while positioning the speaker for the desired orientation. If the Molded Nut is difficult

to tighten by hand, insert the Metal Bar into one of the holes in the outer edge of the Molded Nut and use the bar

as a lever. Be careful not to cross-thread. The swiveling ball enables you to aim the speaker to one side or the

other, or to tilt it up or down.

10. Once the speaker's orientation has been finalized, insert the Metal Bar into one of the holes in the outer edge of

the Molded Nut and tighten the Molded Nut securely. Keep the Metal Bar in a safe place in the event that you

decide to adjust the speaker's orientation in the future.

DOLBY* DIGITAL OR DTS

Use this installation method for Dolby Digital, DTS or

other digital surround processors:

1. Use the line-level input jack marked "LFE" for the

Low-Frequency Effects channel. Connect this jack

to the LFE output or subwoofer output on your

receiver or amplifier. Connect each speaker to the

corresponding speaker terminals on your receiver

or amplifier.

2. Make sure that you have configured your surround

sound processor for "Subwoofer On". Also

configure your receiver for 5.1-, 6.1- or 7.1-channel

operation as appropriate. The front left, front right,

center and rear speakers should all be set to

"Small". If your receiver allows you to set the

crossover frequency between the subwoofer and

the main speakers, select 100Hz or the setting

that is the closest frequency below it.

(OR OTHER DIGITAL SURROUND MODE) CONNECTION

RECEIVER

LFE OUT

SUBWOOFER

LINE

LFE

LEVEL