Da-Lite MULTI-MASK IMAGER Buku Instruksi - Halaman 2

Jelajahi secara online atau unduh pdf Buku Instruksi untuk Layar Proyeksi Da-Lite MULTI-MASK IMAGER. Da-Lite MULTI-MASK IMAGER 8 halaman.
Juga untuk Da-Lite MULTI-MASK IMAGER: Buku Instruksi (12 halaman)

Halaman Cetak

Important Safety

When using your video equipment, basic safety precautions should always be followed, including the following:

1. Read and understand all instructions before using.

2. Position the cord so that it will not be tripped over, pulled,

or contact hot surfaces.

3. If an extension cord is necessary, a cord with a current rating

at least equal to that of the appliance should be used. Cords

rated for less amperage than the appliance may overheat.

Mounting The Frame

Professional mounting techniques should be adhered to. Da-Lite Screen Company cannot be liable for substandard

or faulty installations.

Frame Assembly

Assembly of the screen should be in a clean environment.

1. Connect the four frame pieces by matching the colored

tapes on the ends of the frame pieces. See Figure 1.

2. Secure with the supplied 5/16" setscrews.

Positioning the Frame on the Wall

1. Without the screen fabric attached,

position the frame

on the wall at the location you desired.

2. Make sure the unit is level and plumb.

(You may need

to use shims between the brackets and

the wall to achieve vertical plumb.)

3. Mark the position of the bracket holes on

the wall.

See Figure 2.

CAUTION: If the screen is not mounted

so that it is level and plumb, horizontal

masking may jam on retraction.

Figure 1

Figure 2

4. To reduce the risk of electric shock, do not disassemble this

appliance. Contact an authorized service dealer when repair

work is required. Incorrect reassembly can cause electric

shock when the appliance is used subsequently.

5. The use of an accessory attachment not recommended

by the manufacturer may cause a risk of fire, electric shock,

or injury to persons.

Unpacking and Unrolling the Screen

The viewing side of the screen surface is rolled to the inside.

The screen surface is rolled lengthwise.

1. Remove screen from packaging.

2. On a clean floor, unroll the screen surface viewing side up.

3. Allow the paper to unroll between backside of the screen

surface and floor. See Figure 3.

CAUTION:

•

Be careful not to touch or scratch the viewing side

of the surface with fingernails and any sharp tools.

•

Do not use any tools to fasten the screen surface

to the frame.

•

Do not fold or crease the screen.

Figure 3