Da-Lite MULTI-MASK IMAGER Buku Instruksi - Halaman 3

Jelajahi secara online atau unduh pdf Buku Instruksi untuk Layar Proyeksi Da-Lite MULTI-MASK IMAGER. Da-Lite MULTI-MASK IMAGER 8 halaman.
Juga untuk Da-Lite MULTI-MASK IMAGER: Buku Instruksi (12 halaman)

Halaman Cetak

Mounting The Frame

Attaching the Screen Surface to Frame

1. Place the frame over the screen surface.

2. While lifting the frame with one hand, snap the screen surface

onto the frame. Gently allow the screen to stretch onto snaps.

See Figure 4. Attach the snaps on the top corners and top

horizontal first, lift the frame to a vertical position to finish

attaching the rest of the snaps.

Tensioning the Bottom Masking Panel

1. Carefully remove all tape strips securing surfaces around

rollers. Slats should move freely. See Figure 5.

2. Locate the spring tension cables on either side of the unit.

3. Connect the eye snap to the eyelet on the bottom masking

panel bar. See Figure 5. You will need to pull the cable slightly.

4. Repeat for the other side.

Surface

Tape Strip

Eye

Snap

Figure 4

Slat

Spring Tension Cable

Eyelet

Slat

Figure 5

Electrical Wiring

Electrical wiring is required for each mask roller motor. The

vertical masking systems have one motor at the frame top.

Horizontal masking systems have one motor at the frame top

and one at the bottom.

A motor requires standard 120V/220V input. All connections are

made to the electrical box on the audience left side of the unit.

Horizontal

Mask

Connection

Vertical Mask

Connection

Horizontal

Mask

Connection

Figure 6