American Time SiteSync IQ Panduan Instalasi dan Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Peralatan Perekaman American Time SiteSync IQ. American Time SiteSync IQ 13 halaman. Wireless system controller with standard gps & magnetic mount tx antenna
Juga untuk American Time SiteSync IQ: Panduan Instalasi Mulai Cepat (2 halaman), Panduan Instalasi dan Pengoperasian (2 halaman), Panduan Instalasi dan Pengoperasian (7 halaman), Panduan Instalasi dan Pengoperasian (6 halaman), Panduan Instalasi Mulai Cepat (2 halaman), Panduan Instalasi Mulai Cepat (2 halaman), Panduan Instalasi Mulai Cepat (2 halaman), Panduan Instalasi Mulai Cepat (2 halaman), Panduan Instalasi Mulai Cepat (2 halaman), Panduan Instalasi Mulai Cepat (2 halaman), Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (2 halaman)

SiteSync IQ Wireless Controller

Installation Manual

Tone

The audible tone output is located on the left side of the SiteSync IQ Wireless Controller via a RCA style jack (#4). The tone output

is a low level non-amplified signal intended for input to an amplified system.

Tone Selection

Note: Power should be disconnected and off before making any jumper selections.

Tone Selection

The Tone card (#5) installed on the SiteSync IQ Wireless Controller provides a menu of eight tones of which four can be selected

to be triggered from the SiteSync IQ System Controller. Place up to four jumper shunts at the lettered positions (see above) that

correspond to the desired tones (use Tone Selection Table above). The tones will be assigned to the trigger terminals in the order

they fall into from A to H where the first tone selected on the way from A to H is assigned to SiteSync IQ System Controller circuit

1, the next tone selected is assigned to circuit 2, and so on. If more than four tones are selected via jumpers, only the first four

(from A to H) are assigned to the SiteSync IQ System Controller circuits 1 through 4. If less than four tones are selected, then only

the circuits needed to correspond to the number of tones will be operational.

Clock relays are located on the far right side of the block of 14 screw terminals (#14) inside the wiring panel. (See Appendix B for

wiring diagram)

Tone Selection Table

512 Hz Steady

Slow Whoop

Siren

Mechanical Bell

Klaxon

Night Ringer

Double Chime

Doorbell

*Factory Defaults

Operation