ASTM Mercedes-Benz G 500 Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mobil Mainan Bermotor ASTM Mercedes-Benz G 500. ASTM Mercedes-Benz G 500 16 halaman. Battery vehicle

Halaman Cetak

Remove all parts from the front axle.

1. Slide a Ø10 washer onto the front axle.

2. Slide one front wheel onto the front axle.

3. Slide a Ø10 washer onto the front axle.

4. Tighten a locknut on the end of the front axle with a wrench.

5. "Snap" the wheel cover to the wheel.

Repeat the above procedure to assemble the other normal wheel.

Gap

Position the front wheels 7

After assembling any wheels on the axles, please check the

gap between the screw thread and the collapsible (refer to

the picture below), if the gap is too big, please add two or

three washers inside the wheel, but after tightening the nut

out of the wheel, please rotate the wheel with your finger to

check whether the wheel can run smoothly, this is very

important, because if the wheel can run smoothly, it is ok,

but if the nut presses the wheel and the wheel does not can

work the motor will be broken easily. Then without any

off to ensure

that the wheel can run smoothly.

problems you need to take a shim or two

bottom front view