ASTM Mercedes-Benz G 500 Manual do utilizador - Página 8

Procurar online ou descarregar pdf Manual do utilizador para Carro de brincar motorizado ASTM Mercedes-Benz G 500. ASTM Mercedes-Benz G 500 16 páginas. Battery vehicle

Imprimir página
4
5
Remove all parts from the front axle.
1. Slide a Ø10 washer onto the front axle.
2. Slide one front wheel onto the front axle.
3. Slide a Ø10 washer onto the front axle.
4. Tighten a locknut on the end of the front axle with a wrench.
5. "Snap" the wheel cover to the wheel.
Repeat the above procedure to assemble the other normal wheel.
Gap
Position the front wheels 7
2
3
After assembling any wheels on the axles, please check the
gap between the screw thread and the collapsible (refer to
the picture below), if the gap is too big, please add two or
three washers inside the wheel, but after tightening the nut
out of the wheel, please rotate the wheel with your finger to
check whether the wheel can run smoothly, this is very
important, because if the wheel can run smoothly, it is ok,
but if the nut presses the wheel and the wheel does not can
work the motor will be broken easily. Then without any
off to ensure
that the wheel can run smoothly.
1
problems you need to take a shim or two
bottom front view