AMERITRON ARI-500 Buku Petunjuk - Halaman 10

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Beralih AMERITRON ARI-500. AMERITRON ARI-500 16 halaman. Automatic band switch for the ameritron als-500m; ameritron als-600 amplifiers
Juga untuk AMERITRON ARI-500: Buku Petunjuk (13 halaman)

Halaman Cetak

ARI-500 Automatic Band Switch for ALS-500

The PWR and Link indicator lights will illuminate when transceiver and

amplifier are connected and turned on.

The Red LED marked Link will blink rapidly if the radio jack does not receive

information from the transceiver.

Note About Kenwood Radios

Since the Radio Control Port is used to get the band information from the

radio. The radio must be switched on first before powering up the ARI-500.

Upon power up, the ARI-500 sends the Auto Information (AI) command to

the Kenwood radio. This instructs the Kenwood to send the radio's status

information anytime it changes. Failure to do this will result in the radio not

receiving this command and the ARI-500 not detecting a properly

connected radio.

Anytime the status of the radio changes, there is a one second delay before

the new information is sent over the serial line to the ARI-500. This causes

the switch to appear to respond slowly to the band changes. This is a result

of the delay from the Kenwood radio, NOT the ARI-500.

Technical Assistance

If you have any problem with this unit first check the appropriate section of this

manual. If the manual does not reference your problem or reading the manual

does not solve your problem, call Ameritron at 662-323-8211. We can only help

if you have your ARB-704 manual, radio manual, and information about your

station available during the call.

We strongly recommend calling Ameritron with any questions, but questions

can be mailed directly to Ameritron at 116 Willow Road, Starkville, MS 39759

or Faxed to 662-323-9810. Please be aware that MFJ is a separate facility, and

as such does not always offer the best assistance with Ameritron products. Be

sure to send a complete description of the problem, explain how this unit is

being used, and include a complete description of your station.

NOTES:

Instruction Manual