DoorHan SHAFT-120 Panduan Instalasi dan Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Pembuka Gerbang DoorHan SHAFT-120. DoorHan SHAFT-120 12 halaman.
Juga untuk DoorHan SHAFT-120: Panduan Instalasi dan Pengoperasian (12 halaman)

Halaman Cetak

SAFETY INSTRUCTIONS

4. SAFETY INSTRUCTIONS
•
Read carefully this manual.
•
Have qualified personnel carry out installation and startup of the operator .
•
Open and close the gate by hand, make sure, that it moves smoothly.
•
The gate shall be equipped with balance springs and balanced, otherwise the operator will fail. Before installation of the operator be sure,
that the gate is balanced properly and is in a good working condition.
•
It is necessary to install mechanical stops on the guides, in order to avoid the exit of the gate leaf from the guides.
•
Check for compliance of the mains power with the requirements, specified in this manual.
•
Do not let children use the opening button in order to avoid spontaneous moving of the gate. Never let children play with the automatic
system.
•
Deenergize the operator before putting it into operation, after releasing or before removal its housing.
•
Do not go or drive through the gate during its closing or opening.
•
Do not impede moving of the gate.
•
Control of the gate shall be executed only under condition of its safe moving.
•
Do not pull the chain by hand to open or close the gate.
•
Ground properly all metal elements of the operator and the gate.
•
Be sure, that the leaf is well balanced: if you stop it in any position, the leaf shall remain in this position.
•
In case of failure, unblock the operator and contact qualified technicians.
•
Only the intended use of the operator is allowed, any other use is forbidden.

5. TOOLS

1
5
1.
Set of spanners
2.
Set of slotted and cross screwdrivers
3.
Set of drills for metal
4.
Set of drills for concrete
4
2
6
O PERATO R S HA F T-1 2 0 I N STA L L AT IO N AND O PE RAT ING MANU AL
3
7
5.
Pliers
6.
Hacksaw for metal
7.
Electric drill
8.
Tape measure (folding rule)
4
8