Canon PIXMA MX340 Series Pemecahan Masalah Pengaturan Jaringan - Halaman 7

Jelajahi secara online atau unduh pdf Pemecahan Masalah Pengaturan Jaringan untuk Semua dalam Satu Printer Canon PIXMA MX340 Series. Canon PIXMA MX340 Series 13 halaman. Cartridge reset
Juga untuk Canon PIXMA MX340 Series: Panduan Instalasi (17 halaman), Instal Manual (11 halaman), Panduan Pengaturan Jaringan (26 halaman), Brosur (2 halaman), Manual (8 halaman), Manual (10 halaman), Panduan Instalasi Jaringan (16 halaman), Manual Koneksi (11 halaman), Panduan Servis yang Disederhanakan (35 halaman), Manual (4 halaman)

Halaman Cetak
Canon PIXMA MX340 Series Pemecahan Masalah Pengaturan Jaringan
Check 4
When obtaining an IP address automatically, make sure that the DHCP function of the
access point is active.
•
For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
Enable the DHCP function of the access point, then click Redetect.
•
For details on how to change the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
Check 5
Is the privacy separator feature enabled on the access point?
•
For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
Disable the privacy separator feature.
•
For details on how to change the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
Glossary
•
IP address
A numerical identification assigned to each computer or network device connected to a network.
•
IP address filtering
A function to restrict communication of network devices with specific IP addresses, preventing them from
connecting to the network.
•
DHCP function
A function to automatically assign required information (IP address, etc.) to computers, printers or other
devices connected to the network.
•
Privacy separator feature
A function to prevent communication between multiple wireless devices (such as computers and printers)
connected to an access point.

Problems during Network Setup

WPS

Multiple APs detected is Displayed

Action
The message appears when multiple access points are
detected.
Wait for a while, then configure the settings again.

Cannot connect is Displayed

Check
The message appears when an error occurs.
Check the access point settings, then configure WPS
settings again.
•
For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
•
For the procedure to configure WPS settings of the machine, refer to "Wireless Setup Using WPS
(Wi-Fi Protected Setup)" on page 41 in the printed manual: Getting Started.
•
When using an access point that does not support WPS, configure the settings by referring to "10
Set Up a Wireless Connection" on page 26 in the printed manual: Getting Started.