Canon PIXMA MX340 Series Pemecahan Masalah Pengaturan Jaringan - Halaman 9

Jelajahi secara online atau unduh pdf Pemecahan Masalah Pengaturan Jaringan untuk Semua dalam Satu Printer Canon PIXMA MX340 Series. Canon PIXMA MX340 Series 13 halaman. Cartridge reset
Juga untuk Canon PIXMA MX340 Series: Panduan Instalasi (17 halaman), Instal Manual (11 halaman), Panduan Pengaturan Jaringan (26 halaman), Brosur (2 halaman), Manual (8 halaman), Manual (10 halaman), Panduan Instalasi Jaringan (16 halaman), Manual Koneksi (11 halaman), Panduan Servis yang Disederhanakan (35 halaman), Manual (4 halaman)

Halaman Cetak
Canon PIXMA MX340 Series Pemecahan Masalah Pengaturan Jaringan

Reference Information

Configuring the Access Point's Wireless LAN Settings Manually

Action
Enter the access point name/network name (SSID) and security setting (WEP, WPA,
etc.) directly.
Follow the procedure below.
1
Perform
to
in "Install the Software (2)" on page 27 in the printed manual:
Getting Started.
•
If the Detected Access Points List screen is
displayed, go to
.
2
When the Confirm Connection Access
Point screen appears, click No (A).
•
The Detected Access Points List screen is
displayed.
3
Click Manual Setup (B).
•
The Manual Setup screen is displayed.
4
Enter the access point name/network name
(SSID) in SSID (C).
5
Select the security protocol for the access
point in Encryption Method (D), then click
Configuration (E).
•
Go to either of the following steps according
to the selected Encryption Method (security
protocol).
Disable
Go to
WEP
Go to
WPA/WPA2
Go to
A
B
C
D
on page 8.
.
on page 8.
6-A
WEP
1
Enter the network key in WEP Key (F).
•
Enter upper and lower case letters of the alphabet correctly when the network key is
5 or 13 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 10 or 26 characters (digits).
2
Select Key Length (G).
•
When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select 64 bit.
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select 128
bit.
3
Select Key Format (H).
•
Select Characters when the network key is 5 or 13 characters.
Select Hexadecimal when it is 10 or 26 characters (digits).
4
Select Key ID (I).
•
When using AirPort, select 1 in the screen.
Selecting other key numbers will disable the connection between the machine and
AirPort.
5
Select Authentication (J), then click OK (K).
Go to
E
WPA/WPA2
K
on page 8.
(P.8)
Disable
(P.8)
F
G
H
I
J