DoorKing 8059 RF Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penerima DoorKing 8059 RF. DoorKing 8059 RF 4 halaman. Doorking 8059 rf receiver users guide

Halaman Cetak

Stand-Alone Wiring

1. Connect 12-24 Volt AC or DC power to terminals 1 and 2. If DC power is used, terminal 1 is NEGATIVE and

terminal 2 is POSITVE. Use minimum18 AWG wire to power the receiver.

2. Connect the receiver relay contacts to the device to be activated. Terminal 3 is NORMALLY OPEN (N.O.),

terminal 4 is NORMALLY CLOSED (N.C.) and terminal 5 is COMMON (C). Use 18 AWG wire to connect the

receiver relay contacts to the operating device.

Wiegand Wiring

Terminal 2 is INPUT POWER (12-24 V), terminal 6 is Wiegand COMMON, terminal 7 is Wiegand DATA 0, and terminal 8 is

Wiegand DATA 1. Use 22 AWG shielded wire, maximum 200 feet, for Wiegand wiring. Connect these terminals to the

corresponding terminals on the Wiegand controller. Refer to the Wiegand controller installation manual 1815, 1817 or

1818 for detailed wiring information.

Master Transmitter Programming

The 8059 receiver master transmitter fuction allows you to program up to 4 (four) master transmitters. When a "Master

Transmitter" is activated, the receiver will automatically go into learn mode allowing additional transmitters to be pro-

grammed into the receiver memory.

NOTE:

Master transmitters are not intended to be used as regular transmitters. Keep all master transmitters



in a safe place.

Press and hold the receiver programming button and follow the flashing LED sequence as shown.

The receiver is now in master transmitter program mode. Select a transmitter to designate as a master transmitter

press the button; the button, facility code and transmitter number are programmed into the receiver as a master

transmitter. The button, facility code and transmitter number must match in order to put the receiver into the

regular learn mode.

Transmitter Programming

1. Press and hold the receiver programming button or the "Master Transmitter" button until the programming

LED flashes once (about 2 seconds), and release. The programming LED will flash once every second

indicating that you are in the transmitter programming mode.

2. While the programming LED is flashing, activate the transmitter(s) so that the receiver can record the

transmitter code(s) into memory. A maximum of 80 transmitter codes can be stored in the receiver memory.

3. When all the transmitter have been programmed, wait ten (10) seconds, the programming LED will

come on for three (3) seconds and then go out indicating that the programming sequence has ended.

Wiegand Programming

At least one transmitter code must be programmed into the receiver memory, allowing the receiver to respond to

the facility code and transmitter button that will be used. This step is necessary so that the receiver knows which

button to respond to. For example, if a two (2) button transmitter code is programmed into the receiver using

button 2, the receiver will only respond to transmitter codes initiated by button 2. To have a receiver respond to

both buttons, you can program the transmitter code into the receiver twice, using button 1 and 2. If using more

than one facility code, or if the receiver is to respond to different transmitter buttons, simply program additional

transmitters, refer to Stand-Alone Programming.

NOTE:

The factory setting is for 26-bit and requires a facility code match. You need to program a transmitter into



the receiver, refer to Stand-Alone Programming.

Receivers manufactured prior 11/98 (board program chip REC 2) do not have the programming capability to



ignore facility codes. These receivers will always check the facility code.