DoorKing 8059 RF Panduan Pengguna - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penerima DoorKing 8059 RF. DoorKing 8059 RF 4 halaman. Doorking 8059 rf receiver users guide
Halaman Cetak1. INPUT POWER COMMON
2. INPUT POWER 12-24 VOLT AC or DC
3. RELAY NORMALLY OPEN
4. RELAY NORMALLY CLOSED
5. RELAY COMMON
6. WIEGAND COMMON
7. WIEGAND DATA 0
7. WIEGAND DATA 0
8. WIEGAND DATA 1
8. WIEGAND DATA 1
Receiver Programming
The 8059 receiver responds to transmitter codes defined by facility codes and button numbers. The receiver can
be programmed to respond only to button 1 while a second receiver can be programmed to respond only to but-
ton 2. A two (2) button transmitter can activate two (2) different receivers without fear of both receivers respond-
ing to the same transmitter code and button. Like wise one receiver can be programmed to respond to a specific
facility code while another can be programmed for a different facility code. In Wiegand output mode, you have
the option to decide if you want the receiver to match facility codes or not.
The receiver has seven programming functions:
1. Master Transmitter Programming
2. Transmitter Prgramming
3. 26-bit Wiegand Prgramming
4. 31-bit Wiegand Prgramming
5. Facility Code Match Prgramming
6. No Facility Code Match Prgramming
7.
Memory Erase.
Installation
Install the 8059 receiver in a location where the antenna is not surrounded by metal. For better reception, when
mounting the antenna use a coax antenna kit and amplifier (Coax Antenna Kit p/n 8060-074, Antenna Amplifier
p/n 8058-080). The 8059 receiver is not designed to be installed outdoors, for outdoor installation an enclosure is
required (Outdoor Enclosure p/n 8057-110).
IMPORTANT:
Be sure the antenna, coax shield and F connector are completely isolated from the ground.
When troubleshooting, two (2) Wiegand output LED's are provided on the side of the receiver case. These
LED's will blink as Wiegand data is being transmitted.
PROGRAMMING BUTTON
PROGRAMMING LED
WIEGAND PROGRAMMING LED's