DoorKing 8059 RF 사용자 설명서 - 페이지 2

{카테고리_이름} DoorKing 8059 RF에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorKing 8059 RF 4 페이지. Doorking 8059 rf receiver users guide

1. INPUT POWER COMMON

2. INPUT POWER 12-24 VOLT AC or DC

3. RELAY NORMALLY OPEN

4. RELAY NORMALLY CLOSED

5. RELAY COMMON

6. WIEGAND COMMON

7. WIEGAND DATA 0

8. WIEGAND DATA 1

Receiver Programming

The 8059 receiver responds to transmitter codes defined by facility codes and button numbers. The receiver can

be programmed to respond only to button 1 while a second receiver can be programmed to respond only to but-

ton 2. A two (2) button transmitter can activate two (2) different receivers without fear of both receivers respond-

ing to the same transmitter code and button. Like wise one receiver can be programmed to respond to a specific

facility code while another can be programmed for a different facility code. In Wiegand output mode, you have

the option to decide if you want the receiver to match facility codes or not.

The receiver has seven programming functions:

1. Master Transmitter Programming

2. Transmitter Prgramming

3. 26-bit Wiegand Prgramming

4. 31-bit Wiegand Prgramming

5. Facility Code Match Prgramming

6. No Facility Code Match Prgramming

Memory Erase.

Installation

Install the 8059 receiver in a location where the antenna is not surrounded by metal. For better reception, when

mounting the antenna use a coax antenna kit and amplifier (Coax Antenna Kit p/n 8060-074, Antenna Amplifier

p/n 8058-080). The 8059 receiver is not designed to be installed outdoors, for outdoor installation an enclosure is

required (Outdoor Enclosure p/n 8057-110).

IMPORTANT:

Be sure the antenna, coax shield and F connector are completely isolated from the ground.



When troubleshooting, two (2) Wiegand output LED's are provided on the side of the receiver case. These



LED's will blink as Wiegand data is being transmitted.

PROGRAMMING BUTTON

PROGRAMMING LED

WIEGAND PROGRAMMING LED's