AIR GAP Fluidmaster 6000 Series Panduan Instalasi - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Unit Kontrol AIR GAP Fluidmaster 6000 Series. AIR GAP Fluidmaster 6000 Series 8 halaman. Bottom entry valve assembly
Halaman Cetak
6000 Series AirGap™ Installation Guide
Installation
ON
Step 6
Install the valve through the cistern fixing
hole with the washer inside the cistern
and the nut on the outside. Ensure the
valve is not fouling on the cistern walls
or flush mechanism.
Step 7
Tighten the nut by hand and then by ½
to ¾ of a further turn with an
appropriate spanner/wrench, to
achieve an adequate seal. Be careful
not to rotate the valve and do not
overtighten.
Step 8
Turn the water supply back on ensuring
there are no leaks and the flush is
operating correctly.
Note: There will be a delay between float lift
and valve shut-off and initial cycles of a new
valve may be accompanied by a slight noise.