AIR GUARD AG-700 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat penguap AIR GUARD AG-700. AIR GUARD AG-700 12 halaman. Antibacterial vaporizer

Fluid

Important

Always monitor tank fluid level as you are operating. Running a machine with no fluid can

permanently damage the unit. If you experience low output, pump noise or no output at all, unplug

immediately. Check fluid level, the external fuse, remote connection, and power from the wall. If

all of the above appears to be O.K., plug the unit in again. If vapor does not come out after pressing

the remote button for 30 seconds, check the hose attached to the tank to make sure there is fluid

going through the hose. If you are unable to determine the cause of the problem, do not simply

continue pushing the remote button, as this may damage the unit. Return the machine to your AG-

700 Distributor.

Performance Notes

• All machines develop condensation around the output nozzle. Because this may result in

some moisture accumulation on the surface below the output nozzle, consider this

condensation when installing your unit.

• Machines may sputter small amounts of fog occasionally during operation and for a minute

or so after being turned off.

• All machines have a recycling period after bursts of vapor when the machine will shut down

for a short period in order to heat back up. During this time no vapor can be produced.

• Only for liquids with certified suitability.

Use Air Guard Antibacterial Solution for AG-700. The

machine is tested and calibrated with these authorized

fluids to achieve the best performance. Warranty

will be void, if any other type of liquid is used. Improper

use of liquid may lead to machine failure and danger.

Save these instructions