Coldelite KW-77 Panduan Pengoperasian - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Dispenser Minuman Coldelite KW-77. Coldelite KW-77 15 halaman. Counter model whipped topping dispenser

Halaman Cetak

Part III – Initial Cleaning Procedure

!! IMPORTANT !!.

This is a new machine and although clean, it must

be completely disassembled, washed and sanitized

before adding fresh product. Please proceed as

follows:

Remove the mix tank cover and spare parts items

packed inside the mix tank. The spare parts kit will

include: spatula, cleaning brushes, sanitary

lubricant, oring removal tool, sanitizer packets,

spare orings and seals, and operation manual. Place

these items in a convenient place for future

reference.

Helpful Suggestion: Before proceeding with the

disassembly of the freezer, we recommend the use

of a clean plastic pan or pail to place the removed

parts into. This will minimize the possibility of

misplacing or damaging these components.

You can now start to disassemble the dispenser's

parts for cleaning. First remove the dispensing head

assembly by rotating counter clockwise and pulling

straight off the refrigerated extension.

Remove the texturizer and outer tube by sliding

straight out of the front of the refrigerated nozzle.

Remove the mix pump assembly by rotating

clockwise until the hook stud on the rear of the

pump disengages from the pump hub. After

disengaging, slide the pump away from the rear of

the machine and out of the mix storage tank.

Remove both the mix tank drain plugs from both

the mix tank and front panel.

The machine is now completely disassembled and

the removed parts must now be washed, rinsed, and

sanitized. Using the oring removal tool provided in

the spare parts tool kit, remove all of the orings

from their assigned locations on the dispensers

components.

Wash the removed machine parts in luke warm

(80-90 F) water and mild non-foaming detergent.

Scrub each of the parts with the cleaning

brushes provided in the machines spare parts

kit.

!! IMPORTANT !!

DO NOT use hot water on any of the plastic

parts as this may result in damaging these parts.

Using your three-tank sink, wash rinse, and

sanitize all of the disassembled machine parts.

Mix the Stera Sheen – Green Label sanitizer to

a solution of 100ppm concentration with warm

water. Allow the parts to soak in the sanitizing

solution for 3-5 minutes before removing.

Allow the parts to air-dry on the clean, sanitized

counter at the end of the sink. DO NOT towel

or sponge dry these parts.

2) Rinse

1) Wash

4) Air Dry

3) Sanitize