Asus A7V-VE Panduan Memulai Cepat - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Motherboard Asus A7V-VE. Asus A7V-VE 21 halaman. Athlon / duron microatx motherboard

Halaman Cetak

1. Specifications

2. HARDWARE SETUP

11) Power Supply, CPU, and Chassis Fan Connectors

(3-pin PS_FAN, CPU_FAN, DUCT_FAN)

These connectors support cooling fans of 350mA (4.2 Watts) or less. Orientate

the fans so that the heat sink fins allow airflow to go across the onboard heat

sink(s) instead of the expansion slots. Depending on the fan manufacturer, the

wiring and plug may be different. The red wire should be positive, while the

black should be ground. Connect the fan's plug to the board taking into consid-

eration the polarity of the connector.

WARNING!

The CPU and/or motherboard will overheat if there is no airflow

across the CPU and onboard heatsinks. Damage may occur to the motherboard

and/or the CPU fan if these pins are incorrectly used. These are not jumpers,

do not place jumper caps over these pins.

A7V-VE

A7V-VE 12-Volt Cooling Fan Power

12) Floppy Disk Drive Connector (34-1pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After connect-

ing the single end to the board, connect the two plugs on the other end to the

floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-

tion when using ribbon cables with pin 5 plugged).

A7V-VE

A7V-VE Floppy Disk Drive Connector

CPU_FAN

PS_FAN

DUCT_FAN

NOTE: Orient the red markings on

the floppy ribbon cable to

A7V-VE User's Manual

Rotation

+12V

GND

FAN_SUS#

GND

+12V

Rotation

PIN 1