Asus A7V-VE 빠른 시작 매뉴얼 - 페이지 17

{카테고리_이름} Asus A7V-VE에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asus A7V-VE 21 페이지. Athlon / duron microatx motherboard

2. HARDWARE SETUP

11) Power Supply, CPU, and Chassis Fan Connectors

(3-pin PS_FAN, CPU_FAN, DUCT_FAN)

These connectors support cooling fans of 350mA (4.2 Watts) or less. Orientate

the fans so that the heat sink fins allow airflow to go across the onboard heat

sink(s) instead of the expansion slots. Depending on the fan manufacturer, the

wiring and plug may be different. The red wire should be positive, while the

black should be ground. Connect the fan's plug to the board taking into consid-

eration the polarity of the connector.

WARNING!

The CPU and/or motherboard will overheat if there is no airflow

across the CPU and onboard heatsinks. Damage may occur to the motherboard

and/or the CPU fan if these pins are incorrectly used. These are not jumpers,

do not place jumper caps over these pins.

A7V-VE

A7V-VE 12-Volt Cooling Fan Power

12) Floppy Disk Drive Connector (34-1pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After connect-

ing the single end to the board, connect the two plugs on the other end to the

floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-

tion when using ribbon cables with pin 5 plugged).

A7V-VE

A7V-VE Floppy Disk Drive Connector

CPU_FAN

PS_FAN

DUCT_FAN

NOTE: Orient the red markings on

the floppy ribbon cable to

A7V-VE User's Manual

Rotation

+12V

GND

FAN_SUS#

GND

+12V

Rotation

PIN 1