Advance Appliances ECB 210 Instalasi dan Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Instalasi dan Panduan Pengguna untuk Ketel uap Advance Appliances ECB 210. Advance Appliances ECB 210 17 halaman. Electric combination boiler

Halaman Cetak

IMMERSION HEATERS continued

The 3kw (boost) Immersion heater has an internal control thermostat

which should be set between 70°C and 75°C.

Please note that the immersion heaters are high temperature and

replacements should be ordered from Advance Appliances Ltd.The spares are

listed at the back of this booklet with relevant code numbers.

GENERAL

ALL JOINTS INCLUDING IMMERSION HEATERS MUST BE CHECKED

– THEY CAN LOOSEN IN TRANSIT

ALWAYS FIT A HEAT RESISTANT METAL DISCHARGE/WARNING PIPE

AND FOLLOW CURRENT BEST PRACTICE. IT MUST BE IN A SAFE,

VISIBLE, OPEN POSITION.

SERVICE ANNUALLY AND KEEP SERVICE RECORD

FLUSH AFTER COMMISSIONING, DRAIN DOWN AND RE-FILL

ADDING CORROSION INHIBITOR TO RECOMMENDED STRENGTH

– REMEMBER TO ADD 210 LITRES STORE VOLUME

DO NOT USE HEAVILY CHLORINATED SOLUTIONS FOR FLUSHING

WARRANTY

Warranty is for ten years on the tank against failure due to manufacturing

fault, and two years on components supplied and fitted to the heating manifold

and thermal store.

Conditions apply, the unit must be serviced annually and a record of service

must be maintained. It must be in a frost free environment and must be used

for public mains potable water only. It must be installed and used correctly in

accordance with manufacturer's requirements and current best practice.

Corrosion and scale are not covered. Chlorine/chloride levels must be below

200ppm.The store must be inhibited to correct dose.

Scale is not covered.

Your statutory rights are not affected by the above.

For full terms and conditions see www.advanceappliances.co.uk

DISPOSAL

At the end of the life of the product please dispose of in line with any

regulations ruling at the time.