Doug Fleenor Design PRESET 10 PORTABLE Panduan Pemilik - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Perekaman Doug Fleenor Design PRESET 10 PORTABLE. Doug Fleenor Design PRESET 10 PORTABLE 6 halaman.
Juga untuk Doug Fleenor Design PRESET 10 PORTABLE: Panduan Pemilik (11 halaman)
Halaman Cetak
SETUP AND CONNECTIONS
The Preset 10 Portable should be installed between the console and DMX512 receiving devices. Typically, it should be
within arm s length of the console operator.
Rem ove the cable connected to the output of the console. Use a short DMX512 cable to connect the output of the console
to the DMX512 input of the Preset 10 Portable. Connect the cable that was originally connected to the console to the
DMX512 output connector of the Preset 10 Portable. This inserts the Preset 10 Portable into the DMX512 signal path.
Plug the Preset 10 Portable power supply into m ains power.
NOTE:
!
The console will still operate norm ally when the Preset 10 Portable is not powered.
OPERATION
INDICATORS
RED LED
ON = RECEIVING DMX512
FLASHING = RECORD MODE
GREEN LED
ON = CURRENTLY SELECTED PRESET
FLASHING = TIME SETTING MODE SELECTED FOR THAT PRESET
ALL GREEN LEDS
FLASHING = LOSS OF DMX512 INPUT ALERT - PRESET 10 PORTABLE IS HOLDING THE LAST LOOK.
GREEN LED
OFF
OFF
OFF
FLASHING
ON
W hen the prim ary console is powered ON your lighting system should function norm ally. The RED LED of the Preset 10
Portable will illum inate indicating that a DMX512 signal is present.
RED LED
STATE
OFF
UNIT NOT POW ERED
RECEIVING DMX512
ON
PRESET PLAYBACK IS LOCKED OUT
RECORD MODE ACTIVE
FLASHING
CURRENT LOOK W ILL BE STORED TO NEXT PRESSED PRESET
OFF
TIME SETTING MODE ACTIVE FOR SELECTED PRESET
PRESET 10 PORTABLE TRANSMITTING DMX512
OFF
NO DMX512 INPUT
Page 3 of 6