Baumer DENEX Edge Detector II Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Baumer DENEX Edge Detector II. Baumer DENEX Edge Detector II 20 halaman.

Halaman Cetak
Baumer DENEX Edge Detector II Panduan Pengguna
3.3.2.1 Output Signal – Connections
The output can be used for both "current source" and "current sink" depending on what is
required by the equipment. In current source mode, the sensor output will give a positive
pulse to the stacker/totalizer when active. In current sink mode, the sensor output will give
a negative pulse. Figure below shows a common 24 VDC as power supply and feeding the
pulse. It is possible to have different power supplies. In that case, the 24V power is
connected to pins 1 and 6, and the totalizer can be connected to pins 2 and 5.
Figure 3.3.2.1.1 Electrical connection, common 24V-supply. Current source (PNP).
Figure 3.3.2.1.2 Electrical connection, common 24V-supply. Current sink (NPN).
Copy Sensor
Figure 3.3.2.1.3 Electrical connection, separate supply for power and pulse.
User Manual DENEX Edge Detector II
7/20
Baumer Electric AG
Version 2013-02, V1.6
www.baumer.com
Frauenfeld, Switzerland