Dahua F Series Panduan Memulai Cepat - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Kamera Keamanan Dahua F Series. Dahua F Series 15 halaman. Hd ir bullet network camera
Juga untuk Dahua F Series: Panduan Memulai Cepat (17 halaman), Panduan Memulai Cepat (18 halaman), Panduan Memulai Cepat (17 halaman), Panduan Memulai Cepat (15 halaman), Panduan Memulai Cepat (6 halaman), Panduan Memulai Cepat (16 halaman), Panduan Memulai Cepat (18 halaman), Panduan Memulai Cepat (7 halaman), Panduan Memulai Cepat (17 halaman), Panduan Memulai Cepat (16 halaman), Panduan Memulai Cepat (18 halaman), Panduan Memulai Cepat (12 halaman), Panduan Memulai Cepat (16 halaman), Panduan Memulai Cepat (12 halaman), Panduan Memulai Cepat (13 halaman), Panduan Memulai Cepat (18 halaman)

Halaman Cetak
Dahua F Series Panduan Memulai Cepat
Dahua HD IR Bullet Network Camera Quick Start Guide
It needs to implement the step when the device is equipped with network port
waterproof connector and it is used outdoors.
1)
Keep the convex groove outward and install the rubber ring into the
network port, and keep the smaller hole of the rubber ring outward and
install the fixing rubber ring into the main body of the waterproof connector.
2)
After pulling the network cable without crystal head through main body of
waterproof connector, fixing rubber ring and waterproof fastening cover,
make the crystal connector of network cable and then insert it into the
network cable.
3)
Put the main body of waterproof connector on the network port and rotate it
clockwise to lock the network port and waterproof connector firmly.
4)
Put the waterproof fastening cover on the main body of waterproof
connector and rotate it clockwise to lock the waterproof connector and
waterproof fastening cover firmly.
Step 5 Adjust device angle.
1)
Use inner hex screwdriver to loosen the adjusting screw which is shown in
the Figure above.
2)
Adjust the device in all possible direction, set monitoring direction
according to the application requirement.
3)
Use inner hex screwdriver to tighten the adjusting screw.
Figure 2-3
Figure 2-4
7