Dahua F Series Skrócona instrukcja obsługi - Strona 12

Dahua HD IR Bullet Network Camera Quick Start Guide

It needs to implement the step when the device is equipped with network port

waterproof connector and it is used outdoors.

Keep the convex groove outward and install the rubber ring into the

network port, and keep the smaller hole of the rubber ring outward and

install the fixing rubber ring into the main body of the waterproof connector.

After pulling the network cable without crystal head through main body of

waterproof connector, fixing rubber ring and waterproof fastening cover,

make the crystal connector of network cable and then insert it into the

network cable.

Put the main body of waterproof connector on the network port and rotate it

clockwise to lock the network port and waterproof connector firmly.

Put the waterproof fastening cover on the main body of waterproof

connector and rotate it clockwise to lock the waterproof connector and

waterproof fastening cover firmly.

Step 5 Adjust device angle.

Use inner hex screwdriver to loosen the adjusting screw which is shown in

the Figure above.

Adjust the device in all possible direction, set monitoring direction

according to the application requirement.

Use inner hex screwdriver to tighten the adjusting screw.

Figure 2-3

Figure 2-4