Douglas Dynamics SnowEx V-Pro SP-2000 Panduan Petunjuk Instalasi - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Penyebar Douglas Dynamics SnowEx V-Pro SP-2000. Douglas Dynamics SnowEx V-Pro SP-2000 17 halaman. Utv hopper spreader
Halaman CetakMOUNTING SPREADER
NOTE: Periodically throughout the snow and ice
control season, verify that mounting devices are
secure.
WARNING
Spreader shall be bolted to vehicle frame.
Do not rely on the tie-down chains or straps
alone to hold spreader in vehicle.
CAUTION
Before lifting, verify that hopper is empty of
material. The lifting device must be able to
support the spreader's weight.
1. Remove the tailgate from the UTV bed.
2. Load the spreader onto the UTV bed.
3. Assemble the chute to the defl ector using the
four 1/4" x 3/4" serrated fl ange cap screws and
1/4" locknuts in the supplied hardware kit.
Lit. No. 76451/76452/76453, Rev. 04
MOUNTING THE SPREADER
Chute
Defl ector
8
4. Install the chute/defl ector assembly to the spinner
assembly using the four 5/16" x 1-1/2" tapping
screws and 5/16" locknuts in the supplied
hardware kit to complete the drive assembly.
Spinner
Assembly
Defl ector
5. Mount the drive assembly to the spreader using
the 1/2" x 17-5/8" bent pin and secure it with the
2-3/8" hairpin cotter. Ensure that the bent pin
passes through the small center mounting tab on
the auger drive enclosure.
6. Slide the spreader forward until the defl ector/chute
assembly makes contact with the vehicle. Then
slide spreader back approximately 1" to allow
proper clearance.
7.
Once the spreader is positioned front to back in
the vehicle bed, center it left to right.
February 24, 2020