Douglas Dynamics SnowEx V-Pro SP-2000 Panduan Petunjuk Instalasi - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Penyebar Douglas Dynamics SnowEx V-Pro SP-2000. Douglas Dynamics SnowEx V-Pro SP-2000 17 halaman. Utv hopper spreader
Halaman Cetak8. Looking at the inside corners of the spreader
frame, you will notice four holes in the bottom of
the frame. Using a paint pen or similar marking
device, mark the hole locations on the vehicle bed.
If mounting holes cannot be drilled in the
marked locations, install the optional mounting
bars to the spreader frame using the supplied
1/2" x 1-1/2" carriage bolts and 1/2" locknuts. Use
the existing holes in the mounting bars to mark
drilling locations on the vehicle bed.
CAUTION
Before drilling holes, check to be sure that no
vehicle wiring or other components could be
damaged.
9. Remove the spreader from the vehicle bed and
drill 1/2" holes at the marked locations.
Lit. No. 76451/76452/76453, Rev. 04
MOUNTING THE SPREADER
Cross straps
and secure
to UTV bed.
Ratchet Strap
Optional
Mounting Bars
NOTE: Pay special attention when drilling or
clamping dissimilar metals to aluminum bodies.
Galvanic corrosion can occur if not handled
properly. Contact vehicle manufacturer for
recommended attachment practices.
10. Install the spreader to the vehicle using the
supplied 1/2" x 3" carriage bolts and 1/2" locknuts.
11. Tighten all fasteners according to the torque chart.
12. Install the four ratchet straps as shown below.
NOTE: It is important for safety that this strapping
method be used as the standard mounting
procedure.
9
February 24, 2020