Baumer PMG10P Petunjuk Pemasangan dan Pengoperasian - Halaman 14

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan dan Pengoperasian untuk Konverter Media Baumer PMG10P. Baumer PMG10P 32 halaman. Absolute encoder
Juga untuk Baumer PMG10P: Petunjuk Pemasangan dan Pengoperasian (32 halaman), Petunjuk Pemasangan dan Pengoperasian (36 halaman), Panduan Pengoperasian (44 halaman), Panduan Pengoperasian (44 halaman), Panduan Pengoperasian (40 halaman), Panduan Pengoperasian (40 halaman), Panduan Pengoperasian (40 halaman), Panduan Pengoperasian (36 halaman)

Halaman Cetak
Baumer PMG10P Petunjuk Pemasangan dan Pengoperasian
MOUNTING
4.3
Maximum permissible mounting tolerance when the Baumer Hübner K 35 spring
disk coupling is used
Devices with a solid shaft should be driven through the Baumer Hübner K 35 spring disk
coupling (accessory), that can be pushed onto the shaft without axial loading�
i
The figure below shows the device with EURO flange B10, the same maximum
permissible mounting tolerances are valid with housing foot B3�
)
The device must be mounted on the drive with the least possible angular error and
parallel misalignment�
)
Risk of damaging the ball bearings
Coupling components must not be driven onto the shaft with improper force (e� g�
hammer impacts), because of the risk of damaging the ball bearings�
Admissible
parallel misalignment
* With insulated hub
All dimensions in millimeters, unless otherwise stated�
14/32
2-10
Admissible
angular error
MB261EN - 11196414, 21A1, Baumer_PMG10-Inc_EN_202103_MI_11196414
Admissible
axial movement
±0.7 (±0.3*)