Comat SMS Relay Panduan Petunjuk Pengoperasian - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kontrol Jarak Jauh Comat SMS Relay. Comat SMS Relay 17 halaman. Message system

Halaman Cetak
Comat SMS Relay
5.

Run Mode

5.1

LED status display

The SMS relay has two LEDs, the GSM LED und the status LED. Both LEDs can be seen
from the outside and are located below the cover. The following states are displayed:

5.1.1 GSM-LED

- flashing regularly (every second)
- short flashing (approx. every three seconds) Module is registered but there is no
- Continuous lighting
- Irregular flashing

5.1.2 Status-LED

- dark LED
- intermittent flashing (irregular)
- short flashing (like GSM LED, approx. every 3s) 1x
- short flashing (like GSM LED, approx. every 3s) 2x
- short flashing (like GSM LED, approx. every 3s) 3x
- flashing regularly (every second) 1x
- flashing regularly (every second) 2x
- flashing regularly (every second) 3x
5.1.3 Inputs / Outputs
In addition the states of the inputs and outputs are displayed by means of an LED. These
LEDs are designated as follows:
Inputs
I1, I2, I3, I4, I5, I6
Outputs
Q1, Q2, Q3, Q4
Operating instructions SMS Relay
Module is not registered in the GSM
network.
communication
Communication connection is made
Data are transmitted (SMS)
(LED lighting = input is switched on)
(LED lighting = output is switched on)
Inputs
Outputs
LED positions of the SMS Relay
8
Device does not run
Device starts up
Device runs, everything OK
no credit left
Clock not adjusted
Module in initial state
configuration error
communication error
Status-LED
GSM-LED
ba_smsrelay_0706e.doc