Comat SMS Relay Panduan Petunjuk Pengoperasian - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kontrol Jarak Jauh Comat SMS Relay. Comat SMS Relay 17 halaman. Message system

Halaman Cetak
Comat SMS Relay
5.2

Power failure

Short power failures (t < 1s) are tolerated by the power supply and do not change the module
status.
Longer power failures (t ≥ 1s) are registered and can trigger an SMS alarm message
depending on the adjustment. Afterwards the device shuts down. After restarting the device
the states of the outputs and the registration of the SMS Relay in the GSM network are
restored to the same status as before the voltage failure (Memory function).
5.3

Diagnose

The SMS Relay together with the programming software „FAST SMS Set
the actual signal quality. For that function the SMS Relay has to be connected with a PC /
laptop via the programming cable. To get to the diagnose select "Configuration – Diagnose"
from the menu in the programming software. In addition to the signal quality the diagnose will
display some more information like different version numbers of the device and the firmware.
6
Configuration of the SMS Relay with the „FAST SMS Set"
6.1

General

The SMS Relay is configured and prepared fro use with the „FAST SMS Set
SMS Relay can be prepared before installation i.e. the SMS Relay configuration (telephone
book creation, input messages) can be created without connecting to the device. In order to
do this the software is started, a new or existing file opened and edited. The file created
needs only to be downloaded to the SMS Relay with the CMS-RS232 programming cable. In
offline mode the diagnostics are not active. The diagnostics can only be accessed once the
SMS Relay is connected by the RS232 serial interface to the PC.
6.2

Create connection

•
Switch off the SMS Relay
•
Insert the SIM card
•
Connect the RS232 interface of your PC or Notebook with the SMS Relay programming
interface using the CMS-RS232 programming cable. If your PC or Notebook does not
have an RS232 interface then use a CMS-USB interface converter. With this you can
directly connect the programming cable to one of your USB inputs.
•
Switch on the SMS Relay
•
As soon as the Status-LED of the SMS Relay lights permanently, you can start the
software.
•
Choose the required file or create a new one.
•
For transmission, choose the required COM port on your PC. This is carried out in the
„Configuration – Select port" menu.
Now you are ready to configure the SMS Relay according to your needs or to download the
prepared files.
Operating instructions SMS Relay
9
™
" allow to display
™
Software
™
" software. The
ba_smsrelay_0706e.doc