Downeaster DED LP Panduan Pemilik/Operator - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pemilik/Operator untuk Aksesori Mobil Downeaster DED LP. Downeaster DED LP 20 halaman. Dump body scissor hoist
Halaman Cetak
Locate the push-button control, in the cab and route the cable out of the back side of cab, through a hole in the
back of the cab. Connect the push-button control to the electric power unit using the 3-pin or 4 pin connector set,
or manually tie in each terminal, depending on pump model series. See the pump reference on the next page for
pendant wiring.
Typical Pendant control wiring
Body lighting
Install the wiring harness on the body. Anchor the wiring harness to the wire hangers on the body and the sub
frame. Be sure to leave a ___ inch long loop between the anchor point on the body and the anchor point on the
sub frame to allow for the body to be dumped, without damaging the wiring harness. There should be some slack
in the ___ inch loop when the body is fully raised.
Insert marker lights into rubber grommets, connect the plugs on the wiring harness to the marker lights and
mount the rubber grommets in the holes provided in the rear pillars and the rear rub rail.
Mount the amber reflectors on the 45 deg. front corner. Mount the red reflectors near the rear on the side
posts and on the rear valance near the side ends. MOUNT DECALS IN THE PROPER PLACES. See Figure ___ for
decal identification and placement.
ELECTRICAL
9
Rev B