Downeaster DED LP 소유자/운영자 매뉴얼 - 페이지 9

{카테고리_이름} Downeaster DED LP에 대한 소유자/운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Downeaster DED LP 20 페이지. Dump body scissor hoist

Locate the push-button control, in the cab and route the cable out of the back side of cab, through a hole in the

back of the cab. Connect the push-button control to the electric power unit using the 3-pin or 4 pin connector set,

or manually tie in each terminal, depending on pump model series. See the pump reference on the next page for

pendant wiring.

Typical Pendant control wiring

Body lighting

Install the wiring harness on the body. Anchor the wiring harness to the wire hangers on the body and the sub

frame. Be sure to leave a ___ inch long loop between the anchor point on the body and the anchor point on the

sub frame to allow for the body to be dumped, without damaging the wiring harness. There should be some slack

in the ___ inch loop when the body is fully raised.

Insert marker lights into rubber grommets, connect the plugs on the wiring harness to the marker lights and

mount the rubber grommets in the holes provided in the rear pillars and the rear rub rail.

Mount the amber reflectors on the 45 deg. front corner. Mount the red reflectors near the rear on the side

posts and on the rear valance near the side ends. MOUNT DECALS IN THE PROPER PLACES. See Figure ___ for

decal identification and placement.

ELECTRICAL

Rev B