Follett 5100 Memulai - Halaman 2

Jelajahi secara online atau unduh pdf Memulai untuk Pembaca kode batang Follett 5100. Follett 5100 2 halaman. Corded scanner

Getting Started with the Follett 5100

Installation

1. Carefully insert the modular connector into the bottom of the 5100 until

you feel it click in place (Figure 1). To remove the cable, insert a paper

clip into the cable release hole. (Figure 2).

Figure 1

NOTE: The modular connector cable is speciﬁ cally designed for the

5100 and can only be replaced by a cable designed for this

model.

2. Locate the USB port on the back of your workstation and insert the

USB connector. Make sure that the connector is fully seated in the port.

3. Test your 5100 scanner by using the following procedure:

•

On your workstation, launch a text-editing program such as

SimpleText or Notepad.

•

Scan the test barcode below.

•

Check to see if the number 12345 appears in the text-editor. If the

number does not appear, contact Follett Technical Support at

(800) 323-3397.

NOTE: For best results, scan all barcodes from a distance of 7 to 10

inches.

Page 2 of 4

Figure 2

Getting Started with the Follett 5100

4. Program your preferred sound level by scanning the appropriate

barcode below.

5. If you would like your 5100 scanner to automatically trigger when a

barcode is placed in front of it, scan the Auto-trigger Mode barcode

below. You can return your 5100 to Manual mode by scanning the

Manual Trigger Mode barcode.

NOTE: In auto-trigger mode, the laser will be constantly active.

Page 3 of 4