COMECO TI08-R Panduan Pengoperasian - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Panel sentuh COMECO TI08-R. COMECO TI08-R 13 halaman. Process indicator (trip alarm unit)
Halaman Cetak
Parameter Symbol
Parameters of Level L3
Input Type
Point Position
Input Low
Input High
Input Correction
Icor
Gradient
GrAd
Filter Time
Filter Band
SP Limit Low
SP Limit High
Parameters of Level L2
Direction 1
diR1
+Differential 1
-Differential 1
Time On 1
Time Off 1
Hold On 1
Hold Off 1
The same 7 parameters, but with index 2 – for output OUT2
Parameters of Level L1
Set Point 1
Set Point 2
Access-Control Parameter
Access
Control Level
With potentiometric input, after wiring the device and setting desired values to Input Low and Input High,
*
Input High value differ, to adjust the device to display PV correctly,set new Input High value as calculated
Input High
= Input Low + (Input High - Input Low)
new
Type of the input signal in case of programmable input
inP
Display decimal point position
Pnt
Display value at low limit of the input range
ILo
Display value at high limit of the input range
Ihi
Constant to be added to the measured input value
Maximum admissible input change for 120 ms sampling period
Relative time constant of the input filter
\ t
Zone around the measured value, within which the filter is active
\ b
Set-point low limit
%[L
Set-point high limit
%[h
Control action direction of output OUT1
Relay switching differential over set point for output OUT1
[e1
Relay switching differential under set point for output OUT1
me1
ON duration of pulsed output OUT1
ym1
OFF duration of pulsed output OUT1
y\1
Holds the output OUT1 reaction when being activated
km1
Holds the output OUT1 reaction when being deactivated
k\1
Set-point value of output OUT1
%[1
Set-point value of output OUT2
%[2
(parameter of Hidden level)
Controls the access to device parameters
Qxl
Description
2
/ (PV(100%) - Input Low)