AMS Controls MP328CL Panduan Referensi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Referensi untuk Pengontrol AMS Controls MP328CL. AMS Controls MP328CL 17 halaman. Closed loop backgauge controller

Halaman Cetak

AMS Controls

5/23/2012

The SETUP mode is used when the MP328CL is initially installed

to configure it to the particular characteristics of the Gripper. The

SETUP mode is entered by pressing the "Set Up" key and the

mode can be exited by pressing the "∗" key. When power is

applied to the controller, the built-in diagnostics check the

memory for data retention.

If an error is detected, the memory is automatically cleared and

the SETUP mode is entered to indicate that this data should be

reentered. The setup values are entered in the order shown

below and an explanation of each parameter is given. A form is

provided in the back of this manual for recording the setup

parameters of your machine. This form should be completed

after your machine has been installed and properly adjusted.

To enter the SETUP mode, press the "Set Up" key.

following display will appear.

1=Configure

Selec

3=Loc/Remote

ting

"1"

will allow the operator to adjust the following parameters:

Reference Mode

The REFERENCE MODE parameter tells the MP328CL where

the reference switch is located. The reference point is the center

of the brake where the bend occurs. If the switch is close to the

reference point and most of the moves of the Gripper occur

"behind" the switch, the REFERENCE MODE is NEAR. If the

switch is behind the Gripper and most of the moves are in "front"

of the switch, the REFERENCE MODE is FAR. Use any number

key to toggle the choices.

The switch for a NEAR REFERENCE MODE must be normally

closed and remain open as long as the Gripper is on the switch

or closer to the reference point than the switch. The switch for a

FAR REFERENCE MODE must be normally open and remain

closed as long as the Gripper is on the switch or farther away

from the reference point than the switch.

MP328CL Controller

The

2=In/Out

4=Reference

Gripper