AIRSLED MP3400 Panduan Pemilik - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Jacks AIRSLED MP3400. AIRSLED MP3400 9 halaman. 3-in-1 multi-purpose mover
Juga untuk AIRSLED MP3400: Panduan Pemilik (9 halaman)
Halaman Cetak•
Systems with dial-controlled, VARIABLE SPEED performance (see
figure 4b) can have the rate and height of air beam inflation controlled
making the load less likely to get wedged due to tight, overhead
clearance. If clearance is less than 1", it is recommended you turn up
the air flow gradually.
•
Tilting may occur if the load is not optimally positioned over the air beams. Excessive tilting may
lead to both suboptimal Airsled performance as well risk of injury and/or damage during the load
movement. When all three air beams are used, the operator will need to determine the best locations
for the air beams under the load to minimize tilting. It is common for two of the air beams to be
located under the area of highest weight distribution. Figure 5 illustrates the placement of the air
beams under a load with uneven weight distribution.
GOING OVER POROUS SURFACES SUCH AS CARPETING
All Airsled systems come with plastic Rough Surface Adapters (RSAs). The RSAs are 10" wide x 36" long
and laid on top of the porous surface. The air beams MUST BE PLACED OVER THE RSAs in order for
your system to perform properly. See figure 6. Your system comes with 6 RSAs allowing you to create a
short track to move the load. If moving the load over long distances, heavy carboard paper such as Ram
Board
®
floor protection can be used. See figure 7.
Figure 6
Figure 5
70 – A Aleph Dr.
Newark, DE 19702
Page 4 of 8
Figure 4b
Figure 7
Support Email:
Toll Free Number: 1-800-AIRSLED (1-800-247-7533)