- ページ 5

ジャックス AIRSLED MP3400のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。AIRSLED MP3400 9 ページ。 3-in-1 multi-purpose mover
AIRSLED MP3400 にも：オーナーズマニュアル (9 ページ)

•

Systems with dial-controlled, VARIABLE SPEED performance (see

figure 4b) can have the rate and height of air beam inflation controlled

making the load less likely to get wedged due to tight, overhead

clearance. If clearance is less than 1", it is recommended you turn up

the air flow gradually.

•

Tilting may occur if the load is not optimally positioned over the air beams. Excessive tilting may

lead to both suboptimal Airsled performance as well risk of injury and/or damage during the load

movement. When all three air beams are used, the operator will need to determine the best locations

for the air beams under the load to minimize tilting. It is common for two of the air beams to be

located under the area of highest weight distribution. Figure 5 illustrates the placement of the air

beams under a load with uneven weight distribution.

GOING OVER POROUS SURFACES SUCH AS CARPETING

All Airsled systems come with plastic Rough Surface Adapters (RSAs). The RSAs are 10" wide x 36" long

and laid on top of the porous surface. The air beams MUST BE PLACED OVER THE RSAs in order for

your system to perform properly. See figure 6. Your system comes with 6 RSAs allowing you to create a

short track to move the load. If moving the load over long distances, heavy carboard paper such as Ram

Board

floor protection can be used. See figure 7.

Figure 6

Figure 5

70 – A Aleph Dr.

Newark, DE 19702

Page 4 of 8

Figure 4b

Figure 7

Support Email:

Toll Free Number: 1-800-AIRSLED (1-800-247-7533)