Electrolux # Panduan Pemilik - Halaman 9

Halaman Cetak

Electrical system requirements

Because of potentially inconsistent voltage capabilities, the use of this dryer with power created by gas powered generators,

solar powered generators, wind powered generators or any other generator other than the local utility company is not recommended.

CIRCUIT - Individual 30 amp. branch circuit fused with 30 amp. time delay fuses or circuit breakers. Use separately fused

circuits for washer and dryer. DO NOT operate a washer and a dryer on the same circuit.

POWER SUPPLY - 3-wire or 4-wire, 240 volt, single phase, 60 Hz, Alternating Current.

This dryer is internally grounded to neutral unless it was manufactured for sale in Canada. Grounding through

the neutral link is prohibited for: (1) new branch circuit installations, (2) mobile homes, (3) recreational vehicles, and (4) areas

where local codes do not permit grounding through the neutral.

OUTLET RECEPTACLE - NEMA 10-30R or NEMA 14-30R receptacle to be located so the power supply cord is accessible when the

dryer is in the installed position.

GROUNDING CONNECTION - See "Grounding requirements" in Electrical Installation section.

3-WIRE POWER SUPPLY CORD KIT (not supplied)

3-wire receptacle

(NEMA type 10-30R)

The dryer MUST employ a 3-conductor power supply cord

NEMA 10-30 type SRDT rated at 240 volt AC minimum,

30 amp, with 3 open end spade lug connectors with

upturned ends or closed loop connectors and marked

for use with clothes dryers. For 3-wire cord connection

instructions see ELECTRICAL CONNECTIONS FOR A

3-WIRE SYSTEM.

Exhaust system requirements

Use only 4 inch (10.2 cm) diameter (minimum) rigid or ﬂ exible

metal duct and approved vent hood which has a swing-out

damper(s) that open when the dryer is in operation. When

the dryer stops, the dampers automatically close to prevent

drafts and the entrance of insects and rodents. To avoid

restricting the outlet, maintain a minimum of 12 inches (30.5

cm) clearance between the vent hood and the ground or any

other obstruction.

- FIRE HAZARD - Failure to follow these in-

structions can create excessive drying times and ﬁ re hazards.

The following are speciﬁ c requirements for

proper and safe operation of your dryer.

- FIRE HAZARD - Do not install a clothes

dryer with ﬂ exible plastic or metal foil venting materials.

Flexible venting materials are known to collapse, be easily

crushed and trap lint. These conditions will obstruct clothes

dryer airﬂ ow and increase the risk of ﬁ re.

If your present system is made up of plastic duct or metal foil

duct, replace it with a rigid or semi-rigid metal duct. Also,

ensure the present duct is free of any lint prior to installing

dryer duct.

4-WIRE POWER SUPPLY CORD KIT (not supplied)

4-wire receptacle

(NEMA type 14-30R)

The dryer MUST employ a 4-conductor power supply cord

NEMA 14-30 type SRDT or ST (as required) rated at 240

volt AC minimum, 30 amp, with 4 open end spade lug

connectors with upturned ends or closed loop connectors

and marked for use with clothes dryers. For 4-wire cord

connection instructions see ELECTRICAL CONNECTIONS

FOR A 4-WIRE SYSTEM.

Dryers manufactured for sale in Canada have factory-

installed, 4-wire power supply cord (NEMA 14-30R).

Correct

Incorrect