Bosch Programme Table Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 26

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Mesin cuci Bosch Programme Table. Bosch Programme Table 32 halaman. Front-loading washing machine
Juga untuk Bosch Programme Table: Buku Petunjuk (10 halaman), Panduan Petunjuk Pengoperasian (8 halaman), Buku Petunjuk (8 halaman), Buku Petunjuk (8 halaman), Buku Petunjuk (8 halaman), Panduan Petunjuk Pemasangan dan Pengoperasian (32 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (8 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (8 halaman), Petunjuk Instalasi dan Penggunaan Manual (8 halaman), Buku Petunjuk (8 halaman), Buku Petunjuk (8 halaman), Panduan Petunjuk Pengoperasian (10 halaman), Panduan Petunjuk Pengoperasian (10 halaman), Panduan Petunjuk Pengoperasian, Perawatan, dan Pemasangan (24 halaman), Panduan Petunjuk Pengoperasian (8 halaman), Petunjuk Penggunaan Manual (10 halaman), Buku Petunjuk (10 halaman), Panduan Petunjuk Pengoperasian (8 halaman), Buku Petunjuk (8 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (8 halaman), Buku Petunjuk (8 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (8 halaman), Buku Petunjuk (8 halaman), Panduan Petunjuk Pengoperasian, Perawatan, dan Pemasangan (24 halaman), Petunjuk Pengoperasian dan Pemasangan (29 halaman), Panduan Petunjuk Pengoperasian (8 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (10 halaman), Buku Petunjuk (8 halaman)

Bosch Programme Table Panduan Petunjuk Pemasangan dan Pengoperasian

Water connection

Water supply

Water Drainage

Drainage into a siphon
To prevent leaks or water damage, you must observe the instructions in
this section.
If in doubt, have a technician connect the appliance.
The water supply and Drain hoses can be routed to the left of right,
depending on installation conditions.
Do not use a used inlet hose. Only use the inlet hose supplied or one
which was purchased from an authorised specialist retailer.
Do not allow the water supply hose to be:
– kinked or squashed,
– altered or cut (strength no longer guaranteed).
Note the water pressure in the mains supply:
The water pressure should be between 50-900 kPa (0.5-9 bar) (at least
8 litres of water flow out per minute when the tap is turned on).
If the water pressure is higher, a pressure reducing valve must be fitted.
Connect the cold-water supply hose (blue union nut) to the cold water tap
with ¾" pipe (3/4" = 26,4 mm) thread.
Only tighten plastic screw connections by hand.
Do not remove the filter from the supply hose.
After connecting the water supply hose:
– Turn the tap on fully.
– Check the connections for leaks.
– Do not kink the Drain hose or pull it lengthways.
– Height difference between the installation surface and the Drain:
max. 90 cm, min. 50 cm.
Secure the connection with the 24-40 mm hose clamp (included with the
appliance).
26