Bosch Programme Table Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 27

Electrical connection

Fitting the door hinges

to the washer-dryer

The washer-dryer must only be connected to an alternating current supply

via a properly installed earthed socket.

If a residual current circuit breaker is used, only use a type which displays

this symbol: ‚.

Only this symbol guarantees compliance with the currently applicable

regulations.

The mains voltage must match the voltage specifications on the washer-

dryer (rating plate).

The connected load and fuse required are shown on the rating plate.

Make sure that:

– the mains plug fits the socket.

– the cable cross-section is adequate.

– the earthing system is properly installed.

– the appliance is not standing on the mains cable.

– the mains plug is accessible at all times.

Changes to the mains cable may only be carried out by an electrician.

Do not use multiple plugs/adapters or extension cables.

Do not plug in or unplug the mains plug with wet hands.

Only pull the mains plug out by the plug itself.

Once the washer-dryer has been installed in a kitchen unit, it can be

concealed with a door. If you wish to do this, you must fit the hinges

supplied to the washer-dryer.