Draper Clarion Petunjuk Perakitan/Pemasangan - Halaman 3
Jelajahi secara online atau unduh pdf Petunjuk Perakitan/Pemasangan untuk Layar Proyeksi Draper Clarion. Draper Clarion 4 halaman. Permanently tensioned projection screen
Juga untuk Draper Clarion: Petunjuk Perakitan/Pemasangan (2 halaman), Petunjuk Perakitan/Pemasangan (4 halaman), Petunjuk Perakitan/Pemasangan (2 halaman), Petunjuk Perakitan/Pemasangan (3 halaman)
Halaman Cetak
Addendum for Large Clarion Screens by Draper
➀ Read instructions through completely before proceeding.
➁ Follow instructions carefully. Installation con trary to instructions
invalidates warranty.
➂ Make sure you have received all parts.
➃ Be careful when inserting and sliding brace. The viewing surface could
be damaged if the brace comes in contact with the viewing surface.
Attaching Corner Gussets to Frame
➀ Place corner gusset over frame and attach using screws (provided) (see
Fig. 1).
➁ Repeat for other three corners.
Figure 1
Please Note: Be careful when inserting and
sliding brace. The viewing surface could be
damaged if the brace comes in contact with the
viewing surface.
Figure 2
Please Note: Braces are to be used on wall
mounted screens; suspended screens typically
do not require vertical braces. If one should
be required on a suspended screen, be sure to
attach the brace to the frame to ensure the brace
does not fall out when the screen is fl own.
Width
(Viewing Area)
115" thru 120"
121" thru 168"
®
Copyright © 2008 Draper Inc.
Form Clarion-Addendum_Inst08
Assembly/Mounting Instructions
Caution
Braces
Required
1
2
Printed in U.S.A.
Attaching Braces to Frame
➀ Insert vertical brace into groove on back side of frame, so that tongue fi ts
into slot. Make sure the rivet faces up (away from the screen and frame).
Insert one end of the brace into one groove at a slight angle, then rotate
other end of brace into groove until the vertical brace is parallel with the
frame sides (see Fig. 2). Braces will remain in place; no fasteners are
required.
➁ For large Clarions, one or two vertical braces may be required. For a single
vertical brace, center brace on back of screen frame (see Fig. 3). For two
braces, place each brace approximately one-third of the way in from the
sides of the frame (see Fig. 4).
If you encounter any diffi culties installing or ser vic ing your Clarion screen, call your
dealer or Draper, Inc., Spiceland, Indiana, (765) 987-7999; or fax (765) 987-7142.
Figure 3
Figure 4