Draper D13/5A Petunjuk Manual - Halaman 12

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Bor Draper D13/5A. Draper D13/5A 20 halaman. 5 speed bench drill press

ASSEMBLY Cont'd

11. Make sure the taper of the spindle

and the tapered hole in the chuck

Push the chuck

far as it will go.

12. Open the chuck jaws as wide as possible by

turning the chuck sleeve

sure that jaws do not protrude.

13. Hold chuck

onto the taper of the spindle

and tap with soft faced hammer

chuck, as shown in Fig.13.

14. The drill press is supplied with the belt

installed. However the belt must be properly

tensioned before use by following the

instructions under SPEED/BELT CHANGING

on page 13 of this manual.

Fig.12.

are clean.

up onto the spindle

Fig.13., to make

to the seat

Fig.12.

Fig.13.

- 12 -