Draper D13/5A 사용 설명서 - 페이지 12

{카테고리_이름} Draper D13/5A에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper D13/5A 20 페이지. 5 speed bench drill press

ASSEMBLY Cont'd

11. Make sure the taper of the spindle

and the tapered hole in the chuck

Push the chuck

far as it will go.

12. Open the chuck jaws as wide as possible by

turning the chuck sleeve

sure that jaws do not protrude.

13. Hold chuck

onto the taper of the spindle

and tap with soft faced hammer

chuck, as shown in Fig.13.

14. The drill press is supplied with the belt

installed. However the belt must be properly

tensioned before use by following the

instructions under SPEED/BELT CHANGING

on page 13 of this manual.

Fig.12.

are clean.

up onto the spindle

Fig.13., to make

to the seat

Fig.12.

Fig.13.

- 12 -